Questions & Answers

Unable to complete step 7 in proramming

0 votes
I am able to get to step 6 of the Evo-all chrt6 install in my 2015 ram diesel tip key install.

At the end of step 6 the red led light is on on the evo unit.  I wait several minutes for the lights on teh dash to turn off, and then put the key in the ignition, but i am not seeing the blue led light up.

 

i have triple checked and reconnected the yellow wire to the pink/grn wire as well as both can bus wires to the obd connector, and have double checked the blue and blue/blk wires.

i have checked for voltage on each wire, 12 volts on ignition when on, 12 volts on blue/blk when off dropping to 9v when key is in.  0 volts on blue with it going to 5 when running.  i see 2.5 volts on can lo when on and 3.0 volts on can high when on.

with more monkehying i can now get it to detect the key insert on step 7 but it is not getting to a flashing blue led.
asked Jan 28, 2017 in Ram by willie acklin (130 points)
edited Jan 29, 2017 by willie acklin

1 Answer

0 votes
The module appears to be programmed now, are you still experienceing programming issues?
answered Jan 30, 2017 by Derek (143,450 points)
...