Questions & Answers

2018 Mazda3 install for a manual (6spd)

+2 votes
So it says it will work for a 2018 Mazda 3 Push Start with a MANUAL transmission.

If so, how? I'm familiar with componets and T-harness - This would be my 3rd... Is there a clutch bypass? Does the trans need to be in neutral, if not I assume it wouldn't start - or it would attempt while in gear?

Has anyone else installed on this make/model = gotchyas or problems ??
Has anyone installed on a manual trans = extra steps or worth it (juice worth the squeeze) ??

I've installed on automatics ('15 Town & Country and 10 Caravan) - si I get the over all process with the Harnesses and EVO modules.

 

TY!!!
asked Nov 19, 2019 in Mazda by John S (240 points)

1 Answer

0 votes

Mazda is a completely differen install then the caravan/town & country.

 

Guide will show connection the clutch bypass. 

 

On all manual transmission cars, the unit will never attempt to start if Reservation Mode was not done. This needs to be done after everytime the vehicle has been driven (basically, whenever you park the car). If someone opens a door anytime after reservation mode is set, it cancels the process. https://fortin.ca/en/download/87611/87611.pdf

  • if doing 3xlock start, enable option 33.2 so that reservation mode sets itself after engaging e-brake and then releasing the brake

 

If this vehicle is equipped with adaptive cruise, you need to enable shutdown on door open, option D3, so that the starter shuts down on door open. Or else your cruise will not function. Car needs to be restarted normally. 

 

The harness pins are tight out of factory. Make sure it is fully inserted into the vehicle and fully clipped into place. You could theoricatlly just plug the MAZ3 harness into itself to open up the pins before actually installing it. 

answered Nov 20, 2019 by Robert T (297,620 points)
1. A5 white wire from 20 pin connector goes to which wire in cluth safety switch?

2. if I bypass clutch safety switch with wire loop, do I still need to connect A5 wire somewhere?
Figure it out, connect the LONG WHITE WIRE (A5), NOT the short one to Clutch Safety Brown wire only.

Do not use loop wire to bypass Clutch safety switch since this is push to start button, loop wire will straight start the engine everytime you push the button without giving you chance to go to ON /IGNITION mode
...