Questions & Answers

2013 Equinox 3x Lock Remote Start Issues

0 votes
I have a EVO-ALL (v6) and on the latest firmware.

Chevy Equinox 2013 with standard key, and T harness kit.

Everything should be wired correctly.

I have done the programming and decrypted.

When I press lock three times, my car turns on (dashboard lights up, guages engage, radio on, etc.) but the car doesn't try to start. If I perform a remote start immediately after shutting off removing my key, the car will crank, turnover and shutoff.

It appears to be a failed start (3 red flashes) that I assume is caused by failure to read tach sensor

Any ideas?
asked 1 week ago in Chevrolet by Christian McDonald (130 points)
edited 1 week ago by Christian McDonald

1 Answer

0 votes
What is the service number to the module? The service number can be located on the back of the unit above the bar code.
 
 
answered 1 week ago by Derek (127,510 points)
# 001A06 856376
As stated in the installation guide: http://fortin.ca/download/63371/evo-all_ig_tsa_bi_gm1_lacrosse_regal_verano_c_63371.pdf

 

Flash firmware 4.12 and connect lt.blue to lt.blue/black.

 

Then re test.

 

If doing 3x lock make sure options C1, D1 & D1.10 are on also.
...