Questions & Answers

EVO-ONE won´t enter programming mode with Valet Switch, 2012 Nissan Rogue w/ Intelli Key

0 votes
Installation for 2012 Nissan Rogue with Intelli Key using T-harness and Guide #34741

Module flashed OK with latest firmware ver. 72.19

With Ignition turned on and holding Valet Button, now horn chirp or parking light flash to indicate module is in programming mode.  After about 4 seconds, Red programming LED flashes rapidly but nothing else.  After turning off Ignition, Red programming LED will flash 4x before going out.

Trying to enter programming mode to programm FTX64 RF transmitter Fobs

Is the unit actually in programming mode when Red LED flashes rapidly?  Should the horn and parking lights activate per manual?
asked Jan 22, 2016 in Nissan by Roy Swystun (130 points)

1 Answer

0 votes
After the red led start flashing rapidly (to indicate you are in programming mode) release the valet switch then push it the number of times that is indicated on your installation guide, could be 1x or 5 x, then press and release the brake pedal, the red led should flash once, then push the buttons on the remote controls as indicated in the guide.
answered Jan 22, 2016 by Jesus Monroy (63,860 points)
...