Questions & Answers

2014 VW Tiguan EVO-All EVO-VWT6 TB-VW Starts, and shuts down, shows no key.

0 votes
2014 Tiguan, Standard Key, using EVO-All, Vwt6, and TB-VW along with THAR-TB-VW. The EVO-All programs fine and has been decrypted. Currently using the Factory FOB to 3x Lock to start. Vehicle starts and then shuts down displaying 'No Key'. No wires have been extended. Everything is connected and triple checked.
asked Nov 22, 2021 in Volkswagen by Piotr Garda (130 points)

1 Answer

0 votes
What is the S/N number on the back of the module?

Does the evo try to remote start the vehicle a 2nd time?
answered Nov 22, 2021 by derek g (324,940 points)
The vehicle starts, shuts down, then ignition remains 'on' as. Commanded by the module. I speculate the evo-all considers the vehicle on. S/N 001A07 256314 Can you reset the flash counter? We have tried to reflash it three times now.
If you unplug the 4 pin connector from the tb-vw and place the head of the key infront of the ignition barrell, does the vehicle remote start and stay running?
Yes. It starts fine. I can even pull the fob away from the barrel and the vehicle remains running.
Do you have another tb-vw you could plug in and try?
Unfortunately I do not. Bought this one kit for the car and that's all I have.
enable diesel mode, D1.3
It's not a diesel? What would diesel mode do?
It will give the module more time to perform all the required tasks at start up, definetly worth trying that option.
Got my flashlink in the mail finally instead of driving accross the city to my buddis place to do all this.

Enabled Diesel Mode. Saved options. Connected the module and started the car with 3x lock on factory remote.

Vehicle ran. Displayed "No Key" on the MFD in the cluster, and the factory alarm activated and horn went off.

I double checked thie options to make sure C1 was ticked to YES.

Put the module back into the car. Now it does what it did before. It'll start and just shut down, the only difference is, now the factory alarm goes off.
So I tried to readapt the bypass, and it says I've reached the decryptor limit....
I have sent the module in to be reset. It will take up to 24 hours to be reset.

 

Once done please re flash the firmware and re do the programming. If it still does not remote start at that point call technical support to troubleshoot the issue futher.

1-877-336-7797
Bypass works as should, however the vehicles alarm goes off. >_<;
as long as option d2 is enabled, the oem alarm gets disabled upon remote start. Unless there is a third party alarm installed as well.
D2 is enabled, no aftermarket alarm. Vehicle is stock, I'm the only owner of the vehicle from new.  Just rolled over 74,000 km.

Not sure what to say.

Also, the bypass has stopped working, I'll give tech support a call later today when time permits.
...