Questions & Answers

Evo-one install on infiniti 2008 G37 6 speed manual but only lock and unlock work. Remote start does not work.

0 votes
Hi, I’m installing EVO-one with Omega LINKR-TL2 on a 2008 Infiniti G37 6 speed push to start. I follow the installing guide #33251. I flashed the unit up to the latest firmware. Previously I had a DEI XL202 romote start that connected to EVO one. Tested the unit and only lock and unlock working but when attempt to remote start the car. Only see 3 parking light flash. So I though that it could be DEI XL202 is not functioning correctly so replace it with Omega LINKR-TL2 unit but still have the same result.  I have been talking to Derek for his assistant and suggested to master reset both the bypass and remote start. Reset the module and reprogram with his suggested selection (BYPASS SIDE: A1-A11 -ON, C1 -ON, REMOTE SIDE: 8.2, 32.2, 33.3 AND 38.2)  but have the same result.  I’ve been doing a lot of online researching for the passed 2 week but still no luck. (Now only lock and unlock working) Your help will be much appreciated.
asked Mar 13, 2019 in Infiniti by herbie yang (160 points)

1 Answer

0 votes
Are you setting ready mode before exiting the vehicle?

Also did you follow the clutch bypass on page 5?

 

http://fortin.ca/download/33251/evo-one_ig_thr_bi_nis1_pts_c_33251.pdf
answered Mar 14, 2019 by derek g (324,940 points)
yes, ready mode is set. yes, clutch bypass been done on page 5. But when attempt to remote start. nothing happen except 3X parking light flashes. What is that mean? do I need to enable bypass side:  D2 , D6 and remote starter side: 20.1 for tachless?
...