Questions & Answers

Connecting Python 4806p to Evo-Fort 4 T harness and Evo-All?

0 votes
Hello!  I purchased on Evo-Fort4 that I am going to attempt to install on a 2017 Ford Escape with standard key.  I'd like to use the T-harness to perform all the wiring, using connection points 1 - 6 in the install guide, and then manually making the 22 wire connections.  The plan is then to connect the Evo All to the Python 4806p using the D2D connection; I have updated the Evo All firmware, and activated the F3 option.  Here are my questions/problems:

1) I can't seem to connect the D2D from the Evo to the Python - the Python D2D interface is a larger plug, and neither my T-harness with the Evo or included with the python will fit.  How to connect?

2) Is it reasonable to assume that the *ONLY* connection the Python 4806p will need is the D2D connection, since all power and logic will be piggybacking off of the Evo unit?  In which the Python truly just is the remote starter?
asked Jan 2, 2019 in Ford by Colin Beech (130 points)

1 Answer

0 votes
1) The D2D plug on your Python is the RED connector, on the EVOALL harness you must use the White connector in the datalink harness supplied with the EVOALL

 

2) Correct the Python only receive the remote starter signal, the EVOALL does everything.
answered Jan 3, 2019 by Mathieu Bertrand Collin (62,040 points)
...