Questions & Answers

why after finishing the install and programming pocedure the engine doesnt start??

0 votes
I have an EVO- ALL GMTx preloaded firmware Vr: 70.16 hardware Vr: 6 installed (that came delivered in a EVO RS box with no istructions) went through the installation for a Chevy Cruze Eco Manual Transmission and  after executing the programing procedure doesnt do anything to the car just sits there with a blinking blue light.

yes, the vehicle has the clutch input set up.

any Aletrnatives???

Ive read every manual and evey procedure availabe, same behavior.
asked Oct 2, 2018 in Chevrolet by kenneth mandes (130 points)

1 Answer

0 votes

"I have an EVO- ALL GMTx preloaded firmware Vr: 70.16 hardware Vr: 6 installed (that came delivered in a EVO RS box with no istructions)"

- Correct, modules do not ship with installation guides or instructions, as installation guides are subject to change. You can download them anytime for free on Fortin.ca or when flashing the module, the guides automatically populate in the flash link manager program.

 

A few more details are needed to answer to answer your other issues:

- Year, Make, Model & Trim of the vehicle.

- Automatic or manual transmission.

- What are all the products being installed into the vehicle.

- What guide number have you followed for your installation (first page upper right hand corner will have the guide number)

answered Oct 2, 2018 by derek g (324,940 points)
Vehicle: 2012 Chevrolet Cruze Eco (standart flip key)

Transmission: Manual Transmission

Product: EVO-ALL GMTx preloaded firmware Vr: 70.16 hardware Vr: 6 BOX

Used Guide No.: Guide #28971 (this because of manual transmission)
You have an evo-all, yet followed a evo-one guide?

 

The evo-all when used in stand alone will not start a manual transmission vehicle as stated on the website. (http://fortin.ca/en/vehicles/chevrolet/cruze/2012-standard-key/)

You need a remote starter along with the evo-all for manual transmission vehicles.

 

You should be following this guide: http://fortin.ca/download/63361/evo-all_ig_thr_bi_gm1_lacrosse_regal_verano_c_63361.pdf

 

and you would need to add the clutch bypass as well.
Is that something that coul be purchased separetly to make my current unit work????

Also I see that the Firmware version will change to 70.[26] so that means the everithing i recieved is wrong???
Firmware minimum is 70.26, so anything from there and up will work. you are currently at 70.16 so you need to update the evo using the flash link updater.

 

Yes simply purchase a remote starter that will work on manual tranmission vehicles and follow the guide I linked above, simply add the clutch bypass to the installation.
What are the products numbers to get???
for that car using what you already have you need to purcahse a remote starter of your choice. Also you will need the flash link updater (http://fortin.ca/en/products/accessories/flash-link_updater/) if you dont have one.
...