Questions & Answers

OVE-ONE no LED lights when 6 pin main harness is inserted

0 votes
EVO-ONE with HON2 Tharness and EVO Start module. Programming with Flash Link Updater was completed successfully but when connecting 6 pin main power harness inside the vehicle while holding down the programming button, none of the LED lights illuminate.  Power harness leads were tested with a multimeter and there is 12 volts but the EVO-ONE LED's do not light up so I cannot enter the dcryptor programming mode.  Even though none of the lights on the EVO-One illuminate, the connected EVO Start module has a flashing RED led so there is definitely power going to the EVO-ONE.  

Installed on a 2019 Honda Civic
posté depuis 2 semaines dans la catégorie Honda par StevenM (130 points)

1 Réponse

0 votes
Hello,

 

If the unit does not power up then you would want to check power and ground going to the unit. If both of those check out then I would suggest trying a new module.

Best regards.
répondu depuis 2 semaines par derek g (341,230 points)
...