Questions & Answers

Clutch Bypass 2018 Civic Type R

0 votes
Hello,

I am using an EVO ONE with the HON 7 T-Harness. I have wired everything and cannot seem to get the vehicle to remote start. I read that the clutch pedal stroke sensor needs to be open, by open does that mean I need to simply cut the red wire and leave it loose? Should it be connected to something else?

Thank you for your time.
asked 1 week ago in Honda by Jose Perez (130 points)

1 Answer

0 votes

You need to open the wire only under remote start. 

Wire info: Must open the red wire of the other 4 pin / 4 wires clutch switch may also be yellow

 

Most people do this using a relay and the drk.blue (gwr) wire from the evo-one. 

answered 1 week ago by Derek (180,040 points)
Thank you for your response Derek, by chance would you have any recommendations on what size relay to use?

Also, once the relay is installed using the drk.blue(gwr) wire from the evo-one are there any other steps that need to be taken in regards to programming or will the drk.blue(gwr) wire work fine without needing to go into programming?

 

Thank you so much for your response.
Any standard automotive spdt relay is fine.

 

The drk.blue is already pre programmed as gwr.

 

Then its just a matter of wiring it all up.
...