Questions & Answers

2011 chevy equinox, wont start after installaling EVO-GMT1 stand alone remote start.

0 votes
Installed EVO-GMT1 to my 2011 chevy equinox using install guide " Stand Alone installation with T-harness guide". Programmed module per the guide. Used Dcryptor per Guide, module lights were as on the guide. programming went good and dcryptor went well as well. When connecting module back to vehicle, data-link first than every other connection, notice that when connecting the data-link no ligts came on, in the module, so just went ahead and try to start vehicle nothing. vehicle did not even try to start. also no lights came on in the module. try to start vehicle with key and also nothing. removed t-harnes and module from vehicle and vehicle started fine. reseted module to factory setting and redid all programming that is required and still have the same issue as above. vehicle wont start hitting  3x lock or using key. the only way it starts is if i remove everything from vehicle.

p.s i only removed module and left T-harness and still vehicle wont start with the key. it will only start if i remove T-harness and module. what could be going wrong?
asked Nov 5, 2019 in Chevrolet by AURELIO ZAMORA (170 points)

1 Answer

0 votes
It's normal that no lights turn on after running Dcryptor and plugging module back in to the car.

 

What is the 12 digit service number of the module? If nothing happens when hitting 3xlock, you are missing some options C1, D1, D1.10
answered Nov 6, 2019 by Robert T (297,620 points)

p.s i only removed module and left T-harness and still vehicle wont start with the key. it will only start if i remove T-harness and module. what could be going wrong?

 

this is also normal since by disconnecting the module, you are leaving the immobilizer circuit open. The RED connector needs to be plugged in. Refer to non t-harness installation guide to see what i mean.

OPTIONS C1, D1 and D1.10  were turned on. The 12 digint number is 001A06 710551.

The red connector from the t-harness was connected to the module as well. the connections are exactly connected as described in the installation guide.

I fortgot to ask this, if the module and t-harness are connected like it is on the installation guide the vehicle should start normally with the vehicles key? my vehicle wont start with the key either.
Yes, with everything connected it should be starting normally. If it is not starting with only the red connector in there, get your harness changed.
...