Questions & Answers

THAR ONE HON7 - CRV Push to start

0 votes
Hi, sorry for my english. I bought the whole set of Evo One and Hon7 lastweek.

I already have the guidance for installation but i dont understand the note "Cut3" mean.

When i look at the guide, i said that i need to Cut3 blue cable to D4 and D6 in the pin. What does it mean?

Is it mean i have to cut the blue cable out and connect the remain cable to D6 and D4?!

Or just use some T splice to connect the D6 and D4 to the blue cable.


Please help.


asked Jun 12, 2019 in Honda by Hai Hoang (130 points)

1 Answer

0 votes
You need to cut the blue wire and connect D4 and D6 to either end.
answered Jun 12, 2019 by Robb (232,460 points)
Anyway, i bought it already, just because i though it a lastest version so not cutting stuff.

Is it really a 2 small wires inside that blue cable...i see that the cable is too small already. Can i use t splice to connect those small cable?

and will the remote start function work with out cutting thay cable?


like this. 


"and will the remote start function work with out cutting thay cable?"


No it will not work properly. 

i cannot see the picture, can you send it via my gmail


it will be very helpful to me if i can see how it look in real life.

its the same picture as listed in the guide.


Page 3, where it says cut, cut.

Then connect as shown. 

ah, now i understand something, it mean the wire in the Pin go with D6, and the other ends go with D4...