Questions & Answers

evo-one THAR-ONE-MAZ3 RF KIT PROGRAMMING ERROR

0 votes

2014 Mazda 3 Automatic push to start. Using Guide #68451 for remote programming

I successfully installed the EVO-One with T-harness and the car starts with oem remote with no trouble. However, I am attempting to install the RF642W kit with no success.  When I plug the antenna into the Evo one it will briefly flash blue but then wont illuminate again under any circumstance. I can put the module in and out of valet mode with 3 presses however if I hold the valet button when the ignition is turned on, I don’t get a horn/chirp like the quick installation guide suggests and thus can’t complete step 2 of the programming process. The evo-one and rf kit are new and have not been paired with other devices. Any help as to where i am going wrong would be appreciated

Evo one sucsessfully installed using guide#68261

 

asked Jan 12, 2019 in Mazda by Michael Shave (130 points)

1 Answer

0 votes
I had to power cycle my Evo-one to get different antenna to program. Not sure if that will help you or not.
answered Jan 13, 2019 by Anthony Wilkinson (7,090 points)
I have the same issue of not able to program RFK422 kit.

OECM remote start works fine.

When there is not key plugged in, dongle of RF Kit flashes blue. However when i put key to ON (to program) no led light on dongle.

Appreciate help.

UNIT is EVO ONE with latest 79.65 firmware.

Unit options shows under RF KIT Compatible. only Fortin 2 selected
...