Questions & Answers

mycar telematic programming- evo one

0 votes
hello, i am trying to learn the mycar module to the evo one (2016 subaru impreza firmware 1.24).  the insructions say to hold down the programming button for 5 seconds, but nothing happens when holding it down i tried even longer but got nothing. any ideas?
asked Jan 6, 2019 in Subaru by yehuda flam (410 points)

4 Answers

0 votes
I have the exactr same issue, same firmware version (1.24), except on 2015 Audi A8. I tried all firmware versions down to 1.20, nothing. Commenting here to give this questioin more attention.
answered Jan 6, 2019 by Andriy Kurylov (180 points)
0 votes
Not sure if this is the correct answer but i got it to work if i turned on the ignition than off and back on again and then continued the programming
answered Jan 6, 2019 by yehuda flam (410 points)
Thank you so much for your post. I have a 2016 Ford F150 push-to-start Lariat. In order to program the linkr-lt2 I had to, with the doors closed, turn the ignition on-off-on and then followed the instructions. The Evo-One would not enter valet mode by just holding the valet button for 5 seconds. My link-lt2 is working great with my Evo-One and THAR-FOR-3 harness.
0 votes
Also the "program" button is the valet button. The light you will be looking for is where the yellow loop is that you have to cut for auto.
answered Jan 6, 2019 by Anthony Wilkinson (7,090 points)
0 votes
I have a 2016 Ford F150 push-to-start Lariat. In order to program the linkr-lt2 I had to, with the doors closed, turn the ignition on-off-on and then followed the above instructions. The Evo-One would not enter valet mode by just holding the valet button for 5 seconds. My linkr-lt2 is working great with my Evo-One and THAR-FOR-3 harness.
answered Mar 29, 2020 by Jesus Sanchez (150 points)
...