Questions & Answers

location of IMO wire in australian spec sti my17

0 votes
I'm doing a australian delivered my17 subaru sti (push-to-start) and I don't seem to have a wire in the location discribed for the Immobilizer, pin 25 red/white wire. I was hoping someone had another location to pick this up? Would this affect the firmware aswell ? Everything else on the diagram is present.
asked Jun 20, 2018 in Subaru by David Ancrum (130 points)
edited Jun 21, 2018 by David Ancrum

1 Answer

0 votes
Is your WRX STI Push-to-Start or Key Start?
answered Jun 20, 2018 by derek g (324,940 points)
sorry the vehicle is push-to-start
The pin is empty or is there a red/white or green/black in pin 25?
yes pin is empty. Would a picture of the 35 pin plug showing the pins populated etc be helpfull? If so is there an email address to direct it to.
support@fortin.ca

 

connector should look like this http://image-3.wirecolor.com/vehiclegroupimage/127741.jpg
if not present, you might need to go to the ECU under the hood.

green/black , pin 43 of a 48 pin connector

ECU has 3 connectors. Should be in the first connector.

 

Make sure the light blue / black wire from the evo goes to the ECU side of the immo wire after cutting it.
I'm pretty sure the sti model doesn't have a ecu under the bonnet. Does anyone have any other listing or idea to figure out where i would beable to locate the Imobiliser wire?
What is the complete VIN to the vheicle?
Vin is -----------
...