Questions & Answers

no functions working on evo one 2013 tacoma

0 votes
Followed guide 18861 for 2013 Toyota Tacoma v6 manual

programming went fine where the red and blue lights flash then a rapid blue light.

have everything wired from the diagram correctly. Doubled checked wires. Are there any other wires I have to connect besides the guide?

I have crimestopper revo 4 remotes.

Maybe the firmware is wrong. Had the dealer check 3 times
asked Feb 9, 2016 in Toyota by David Tran (130 points)

1 Answer

0 votes
What functions are you referring to?

If it is doorlock control, you will need to connect analog wires to the vehicle since we do not list those features as controlable through canbus.

Thank you.
answered Feb 9, 2016 by Jesus Monroy (63,860 points)
Please read the user's manual for the Revo RF kit to figure out which button to push to remote start the vehicle.

As for the parking lights, how did you connect to the vehicle? Please specify which wire you used and which wire in the vehicle it was connected to.

Thank you.
I tried every way possible on the remotes. I have the pink wire from the evo connected to the green wire on the light switch.
if you disconnect the pink wire from the vehicle, can you test it with a logic probe to see if there is a constant ground coming out of that wire,

Also if your vehicle is automatic transmission, did you cut the yellow loop on the side of the unit?

Thank you.
I'll test it when I get home after work. But on my previous module the lights were flashing just fine. As soon as I plug in the new module the lights stay on. I did not cut the loop. I have a manual
Since you have a manual transmission vehicle, are you putting the vehicle in "reservation mode" or "ready mode"?

This step is necessary for manual transmission vehicles to ensure that the vehicle is not in gear.

Thank you.
...