Issue with brown/white providing neg output

Question

I have a 30amp 4 pin relay and hooked it up as noted on this forum. I cannot get it to turn on the parking lights while the remote start is running. Any support would be welcomed. 2007 Jeep Wrangler.

Answer 1

Can you tell me how you hooked up your relay (pin connections please)

Comments

I did the following: Pin 85 to Brown/White wire from Evo Pins 86 & 87 to 10amp fused line to vehicle constant Pin 30 to the parking light wire. I verified this is correct. When i give it power it lights them up. When they are on my multimeter shows 8amps. Not exactly sure how to test the brown/white wire

---

Is the relay clicking when you lock and unlock or start the vehicle?

 

if you disconnect the BROWN / WHITE wire from the Evo All and pulse pin 85 of your relay with a wire connected to Ground, do your parking lights light up?

 

You can test the Brown / White wire with a multimeter set to DC voltage, put your RED probe to 12v constant and the black probe of your meter to the Brown / White wire of the EVo All,

 

If you start the vehicle, your meter should show 12 volts if the Brown / White wire is outputting a ground properly.

---

Thanks. The relay works fine. The brown/white wire does not produce a negative output while the Evo is running. :(