manual transmission programming with evo all on ford fusion 2008 manual

Question

I update my evo all to 71.11 recommended by program and use connection 2 in guide but I'm not able to program for manual transmission because after I put the 12 volts at the ignition 1 wire the led stay red and never flash 10 x. I'm able to program with program 6 (one key) easily but the module doesn't manage hood status, brake status, hand brake status and trunk opening but the car start well with car remote and doors work fine.

Answer 1

What's the remote starter you are using. Using 1 key programming or 2 key won't change anything to status or trunk opening.

Comments

yes, but actually if I start the car with remote and drive for 5 minutes the remote stay on and the car stay controlled by remote and the remote never detect that I drive the car because it seems didnn't see any signal from eVO ALL. Stange

---

Not strange, normal reaction for a remote starter that never see brake signal. Does the brake wire from your remote starter is connected to the black wire on the evoall ?

---

Yes but the remote keep the control of the car, I will connect directly to the brake switch because the remote need 12 volts to shut down.

---

I am just curious too know what color the can wires are on this car that you are connected too.

Also, testing that black wire output from the 20-pin connector with ignition on should also give you 12V when pressing the brake. Brake status always works and has always worked on these cars.

In any case, you can always wire the brake input of the remote starter directly to the vehicle.

---

I recheck carefully my connection the Gray wire is connected to gray/orange pin3 OBDII and the Gray/Black is connected to Violet/Orange pin 11 OBDII and the connections are good to 20 pin white connector. Connection 2 on your website.

I tested the black wire and there was no 12 volts when the key is on and the brake pedal pressed. the brake status don't work at all even if I connect the black wire to the wire for brake on the remote starter.

The lock unlock works fine via Can Bus.