Questions & Answers

2012 Toyota Corolla G-key and EVO-ALL Programming Problems.

0 votes
2012 TOYOTA Corolla G-key and Fortin EVO-ALL:

Connections: Ignition 1: Connected to A1 Fortin EVO-ALL. CAN LOW: PIN 14 OBD-2 Diagnostic port to C4 Fortin EVO-ALL. CAN HIGH: PIN 6 OBD-2 Diagnostic Port to C3 Fortin EVO-ALL. Immobilizer Data: PIN 7 OBD-2 Diagnostic Port to A10 Fortin EVO-ALL. ALL other connection go trough DATALINK D2D.

Problem: Installation Procedure 5: The red light never flashes 10x times after turning the Ignition to ON/RUN Position. Waited 1 hour and the red light never flashed 10x times neither the blue light. Tried few times and 3 different EVO-ALL.

Fortin EVO-ALL was flashed previously with the firmware of car model and year suggested by Flashlink Manager: Firmware 79.12 Hardware: 6.

Somebody has a clue on how to solve this issue or what could be wrong. Thanks in advance.
asked Jun 11, 2014 in Toyota by Arnold Richters (130 points)

1 Answer

0 votes
Arnold,

 

Try using a different key. The Valet key will not allow programming.

you should also not be waiting an hrour for the LED to flash.

Make sure the physical connections are good, test for continuity between the vehicles wire and the pins on the EVO.
answered Jun 11, 2014 by Robert T (297,620 points)
...