Questions & Answers

Evo-all will not work

0 votes
Hello. I am attempting to setup an Evo All. SN#001A07406644. I go through the guide and I can not get the unit to start the vehicle. Can someone help me figure out what is going wrong? Vehicle is a 2019 Toyota Highlander. The last attempt I made I performed the in car programming. The did the Dcryptor program. After plugging the unit back into the car I have no leds until I go to on ignition position then yellow led comes on and stays on until the car is shut off.
asked 1 week ago in Toyota by kenneth rocha (160 points)

1 Answer

0 votes

The unit seems properly set up . 

Please try the following, in the exact order

  1. RESET the EVO-ALL
  2. After the RESET, you will have to enable options; C1 , D1 , D6 , H , H2 . Turn OFF option A11. 
  3. Reprogram the module to the vehicle
  4. Redo Dcryptor 
  5. Reconnect to Car
  6. Enjoy

 

To reset the EVO-ALL. 

  1. Hold down programming button while plugging in the 4-pin black connector.
  2. Let go of button when LED is RED.
  3. Push and hold button again until all three LEDs start to alternate.
  4. Disconnect unit, it is not reset
answered 1 week ago by Robert T (280,210 points)
...