Questions & Answers

Door trigger stays open when connecting the 20 pin, remote start works okay.

0 votes
Hi, Everything works fine with the remote start however, the door ajar light in the dash stays always on. And when I disconnect the 20 pin connector, then the door ajar works fine. I have connected the dk.blue wire to the lt.green wire at the fuse box as instructed. Also I have programmed the 32.5 option. The car has oem alarm. SN 002B04 251304 Any ideas? Thanks
asked Sep 5, 2022 in Mitsubishi by Mikko (240 points)

1 Answer

0 votes
Please try enabling option 32.3 instead and let me know if the light goes away.

 

Thank you.
answered Sep 6, 2022 by derek g (324,940 points)
Hi,

Just tried it, no change. Also looks like the factory oem alarm does not arm, guessing it is thinking the door is open.. Btw the car is Eclipse 2012 standard key.

 

Also, if I disconnect the dk.blue wire from the door trigger, the door ajar works fine, but the remote start will just crank without starting.

Thanks
"Also, if I disconnect the dk.blue wire from the door trigger, the door ajar works fine, but the remote start will just crank without starting."

 

- please remove the door pin connection and then relocate the ground for the module to a new location. Once that is done re test the remote starter.
...