Questions & Answers

2010 Toyota Sequoia Power Lift Gate

0 votes
I recently installed the Evo-one along with the rfk942 remote/antenna.

I wired the Evo-one as per

Am I able to operate the power lift gate with this combination?
asked 5 days ago in Toyota by gullygossner (160 points)

1 Answer

0 votes
red wire at the liftgate switch is the trigger.

You can use the (-)Trunk output, Yellow/Black from the evo 20-pin and wire it straight to that.

Always test the vehicle wire first! It should be a negative trigger.
answered 5 days ago by Robert T (272,030 points)
Thank you for the answer Robert! Does it require any changes on the firmware side?