Questions & Answers

evo all ford escape 2018

0 votes
ford escape 2018 standard key with evo all not programming with 2 keys and also not programming with one key

programming with 2 keys after cycling both keys i press and hold programming bottun the ignition has to com on but its not and all three lights on evo all on solid checked all connection and also i swiched the RX and TX to make sure they are not reversed still same issues i flashed the evo all to diferent version still didnt help me .

need some tech support please

service number 001a07219180
asked Sep 4, 2021 in Ford by mathew matt (570 points)

1 Answer

0 votes

Although the 2 key programming has a few limitations in regards to things like needing two master keys, the 1-key programming has no reason not to program if connections are ok.  Not just Rx-Tx, but KeySense and CAN-HI & CAN-LOW.

 

Confiming CAN-HI, CAN-LOW and Keysense is easy. Try programming ONLY the CAN-BUS first.

  1. Hold button while inserting the power and release when the LED is BLUE.
  2. Insert the Key (blue led will go out, this confirms keysense)
  3. Turn Key ON. 
  4. BLUE LED will start to flash rapidly if CAN is ok.
answered Sep 7, 2021 by Robert T (297,620 points)
the main harness conection to remote starter all verified mor than one time power accesory ignition and key sens  can high can low allso verified .

with one key allso folowed by the programming guide the red and yellow stays one solid no any changes.

with two keys all three lights red yellow blue stays on
With the 1 key programming method, if red & yellow are staying on when the key is turned on, that typically points to an issue with Rx-Tx. Check those connections, but also check the EVO connector to ensure their is no bent pins.

 

You can also flash down to 71.49 .
...