Questions & Answers

Evo one 2008 mkz regular install, need to know where to hook alarm

0 votes
Need to know where to hook up my duel shock , and siren on evo one wire to wire. Guide 88581 also going to use compustar 901 remote. I believe I only have to swap the rx/tx wire.
asked Mar 29, 2021 in Lincoln by Jeremy Boven (480 points)

1 Answer

0 votes
Here is the alarm guide: https://fortin.ca/en/download/16221/16221.pdf

 

Purple/White is the shock sensor input.
answered Mar 29, 2021 by derek g (324,220 points)
This guide is for evo all. I'm using the evo one. Thx
On an evo-one you would plug it into the 3 pin shock sensor port on the side of the unit. You would then enable option 14 in the rs side of the module to activate the alarm.
Then where am I hooking the siren on the evo one ?
Siren would be the orange/black after you confdigure option 12.

 

https://fortin.ca/download/33021/rf642w-install-guide-33021.pdf
Ok option 12 what... for the orange/blk wire ? What all options are needed to be selected. Now on this duel shock sensor do I tie both trigger wires together and run to center pin of 3 way plug.. is that a multiplex input. Because I would like pre warn also. Then for my 3rd question where shall I tie in my tilt sensor. I would like it seperate in case I want to disable it. Thx derek.
Also option 12.4 is negative trigger. Is this what I need. Why not the white main wire for accessory2 since it's not being utilized in this car. Then what about the harness main output. Option 2 ?
You can use orange/black or the large white wire on the main 6 pin connector if it is not used in the installation.

 

Option 12 in the remote starter is how you configure what wire youll be using and how it will react.
...