Questions & Answers

2016 Ford F150 with Fort 3 harness not starting truck after first programming

0 votes
Have installed the Fort 3 t harness , Evo all has been flashed with Flashlink 4.

Firmware 4.02 A11 off and C1 selected.

Completed module installation and truck starts when pressing lock 3 times.(when reprograming module the truck always starts on first test only)

Upon an second attempt to press lock 3 times results in module goes red, orange and then blue, truck horn honks.(no start)

it tries to do this two times and then 3 red lights blink on the unit.

When opening door truck warns of alarm going off unless i insert key.

Please can you advise.

 

Thnak you very much
posté Nov 1, 2020 dans la catégorie Ford par Andrew Dick (130 points)

1 Réponse

0 votes
Think we just spoke. Let me know if the hood connection got it up and running.
répondu Nov 2, 2020 par Robert T (300,020 points)
Hi Robb,

 

Thanks for the help over the phone.

I put in a loop at the hood latch connector cable (2 wire connector.)

I have done the test about pressing lock twice, truck only beeps once.

The remote start still is only holding the programming for one start.

After the one start, i jump in truck and put key in. Start truck then trucn truck off.

This is when i get out of truck. I lock the truck (one button press)

Then i do three not to fast pushes of Lock, Module shoes:the red light comes on then the amber then the blue and notstart, tries this two times and then flashes red (2-3 times).

 

Please help.

 

Thanks sir
...