Questions & Answers

where did I stuck with evo all?

0 votes
I bought me a new one EVO ALL (2014) from e-bay ( Cause, I have been told device made under 2013 will not work )  : The Service No: 00A06 759436. Programmed and updated with the  internet 2009 escape standerd key  : Option; D1 is OFF= not to confused the car ,and A 5, A6 are OFF = not to let car start by itself . Every step went well as estated in the  guide #34451(regular installation) last step: Yellow and red leds alternated.Good.
Did the DCRYPTOR + Updated the device,then plugged it  into the car : Tried to remoe start, result ; Ignition turns on , no crank and no start . Did the DRCYPTOR  twice with no problem with link -manager . Put the car- key in the ignition to TEST : Car remote started fine .Leads to two things : Something wrong either the EVO ALL or it's wiring . All wiring connections look fine ,No problem with the programming (evo all- steps : on pagr 6) . So, did I miss something,here?. My problem I have ONE KEY for this car,other wise, I wouldn't use the Drcyptor. Iam stuck . I Need  help and thanks to every one.
Service Number : 00A06759436
asked Jun 28 in Ford by Daud Suleiman (190 points)

1 Answer

0 votes
What do the led's on the evo all do when you try to remote start the vehicle?

What type of remote starter are you using the evo-all with? what protocol have you set the remote start module to?

Dcrpytor is working so issue is not with programming.
answered Jun 28 by Derek (117,210 points)
edited Jun 28 by Robb

 The EVO ALL:  Led turns YELLOW .I am using  ProStart - Model #: CT-5472TW with basic programming options except mode4 ,function 6 :Bypass type = option 1( fortin) . Page 20 http://www.prostartsystems.com/Docs/CT_5472%20TW_ig_en_h5xs4x.pdf . The protocol :F3:D2D.  
Found the solution : lowering the firmware to 71.35 and reprogram the unit.Thanks Derek.

...