Questions & Answers

CAN BUS PROBLEM

0 votes
hello having a problem with the device as the when EVO ALL is connected , the car doesn't go to sleep mode and remains draining battery with current drainage of (0.2 amps) , normally without the device it's (0.02 amps) when it's disconnected, it goes to sleep mode and current drain stops i tried all possible settings ON and OFF, nothing changed i tried to disconnect cable by cable each time untill i identified Cable (C) which is containing the brown wire C5 only when i dosconnect this cable , Car goes to sleep mode and current drainage stops the problem i cannot keep it disconnected as the module is not functioning properly without C5 being connected to it's place can you give me any tip or solution for this   Car is Buick Regal Service number is 001A06839987 Radio is having android interface attached with the car main screen that is normally shutting down with car CAN BUS, but when EVO is attached it never shut down and this is the main source of power drainage
asked Nov 10, 2020 in Buick by Mohamed Ali (460 points)

2 Answers

0 votes
Probably a data collision issue between the 2 aftermarket pieces.

 

This can happen when adding multple after market pieces to a vehicle.
answered Nov 11, 2020 by derek g (339,570 points)
So any solution can be done ?
I do not know of any solution at this time.
0 votes
Is the a Maestro installed? If so, contact Maestro.

EDIT: Turn off option G.
answered Nov 11, 2020 by Robert T (300,020 points)
edited Nov 11, 2020 by Robert T
It's not Maestro, the interface is Navitech GM77 Aplus, already tried option G off, nothing changed
If they are not using SAE certified CAN drivers, as derek said, you are most likely having a data collision.
So no hope ? Any device can be used to solve this ?
...