Questions & Answers

CX-3 2018 is only remote starting when I am in the vehicle

0 votes
I have the evo-one with the thar-one-maz3 harness.

I have cut the yellow loop.

On the bypass side I have verified that options A1-A11 & C1 are enabled.

On the remote starter side I have enabled  38-5

When i try lock-unlock-lock in the car, it works on the second remote start attempt. It worked on the first attempt just once and after multiple tries after that it is taking two attempts, it turns on the radio etc then turns off, then there's a horn honk,  then the interior electronics turn  back on and the car starts.

When i try this outside of the vehicle, i just hear the horn honk twice, about 30 seconds apart, an no starting occurrs.

The car is within range of the keyfob as it is reacting to each lock-unlock-lock i push (within 8 seconds).
I have tried pushing the lock unlock lock one second apart, then faster, then slower.
I went and sat back inside the car to verify that lock unlock lock is starting it, after its second attempt.

Any ideas? I am doing the lock-unlock-lock to avoid the unneeded horn honking so having it start on the second try after a horn honk is not ideal. But again that only works when I am sitting in the vehicle. It is not starting at all when I am outside of the vehicle.
asked Feb 19, 2018 in Mazda by chris root2 (250 points)
edited Feb 19, 2018 by chris root2

1 Answer

0 votes
Turn off option 6.2 save the option and re test.

 

If your vehicle is indeed equipped with a factory alarm you want to enable option D2 not 6.2.
answered Feb 20, 2018 by derek g (324,940 points)
I have tried turning 6.2 off, it doesnt start at all, i left 6.2 off and turned D2 on, it still only remote starts when i am in the vehicle
is there anyone who can provide some insight on this issue
Try lowering the firmware to 71.44, reset the evo as shown here: http://wirecolor.com/en/qa/50193/faq-how-do-i-reset-my-evo-all?show=50193#q50193

Re program the evo including dcryptor.

Re enable option C1 and re test.
i wasnt able to get it to factory reset but i reverted the fw and redid the decryptor and it is working
...