Questions & Answers

Evo-All Mazda cx5 2018 Programmed but, won't start. Red and Yellow Leds, and clicking relay

0 votes
I'm going nuts. I've tried everything multiple times and still struggling with this.

Blue leds flash with every button. I am getting red and yellow leds when I try to start with 3x lock. The relay for the lights click several times. I keep reading that it should be the hood pin, but when I try jumping the pins under the hood, my car goes nuts and throws a ton of errors. I tried grounding the blue wire from the large connector on the evo-all, and then it wouldn't even attemt to work. (I disconnected that wire.) I've been through every connection several times with a volt meter checking continuity and I just can't seem to find anything to solve this. Is it in my options?

I went back to the Flashlink and changed all the settings to default suggested settings.

I'm getting 4 or 5 light flashes. I know the fobs are not in the car. So, it has to be hood.?

Never mind, Got it... the wire I used under the hood to jump the pin was frayed a little at the end and must have been shorting on a nearby pin. I know I ran accross someone else's question with the same errors on the dash. I hope this helps. Cheers!
asked Nov 17, 2018 in Mazda by Neal Meeker (260 points)
edited Nov 18, 2018 by Neal Meeker

Please log in or register to answer this question.

...