Questions & Answers

Hazard lights flashing intermittently

0 votes
Unit is installed and starts the car. When driving the hazard lights will begin flashing intermittently. Is there a possibility that a circuit is being completed by wires touching?
asked Dec 18, 2017 in Jeep by Adam Green (130 points)

1 Answer

0 votes
Yes it is a possibility but the hazards wires are not used by the remote starter. Verify every harness where you have connected wires to make sure you didn't hurt other wires.
answered Dec 18, 2017 by Mathieu Bertrand Collin (62,040 points)
I pulled it out again and looked at everything. All the wires look fine. Could it be that the yellow ignition wire wasnt secure enough?

 

I drove the car, the doors would unlock and the hazards would flash a few times. Then turn off again. It would seem it would happen at low speeds, while braking or coming off a stop.

Thanks for the help
What is the service number on the module ? Is the vehicle manual transmission ?
Sorry for the late reply

 

The jeep is automatic.

 

Service number on the module is: 001A06 747906
Bumping this comment back up
Hi -

 

Not sure if I should start a new thread to get this going again. Or if my replies weren't notifying because I was answering my own comment.

 

Thanks for the help - Not sure if I should return the product or not at this point
The EVOALL does not have the capability to turn on the hazard lights.... Might just be another problem with the vehicle
Adam- did you find any solution on this?  This is currently happening to me as well- 2015 Jeep Wrangler randomly unlocks doors and flashes hazards while driving.  Thanks for any info!
...