Questions & Answers

Tahoe 2006 Fortin evo-one+RF642W

0 votes

Evo-one, It is established according to Guide # 23261, +RF642W. No remote start. The starter does not twist. When doors are closed, it is armed. When unlocking the door is not disarmed.

Regards,

Viktor.

asked Oct 29, 2017 in Chevrolet by Victor Podverbny (250 points)

1 Answer

+1 vote
Does the ignition light up when trying to remote start vehicle?
answered Oct 30, 2017 by derek g (324,940 points)
No. But I hear the relay click into the block. If I repeat the remote start attempts several times, the yellow indicator sometimes blinks briefly.
I tried everything, master reset, programming, firmware 70.21 and 70.30. The result has not changed.
When the ignition is switched on with the key, the yellow indicator lights up.
I think the following (and / or):
1. There is no car identification during programming.
2. Incorrect setting options. Now installed by default.
3. Not a valid firmware version.
4. Why is not disarmed when unlocking the doors.
 
I hope for your help. Thank you.

 

Try using version 70.18 re program and re test.

 

Do lock and unlock work from rf kit?
Good. I'll try version 70.18 and report the result.

Yes, lock and unlock work from rf kit.

Also if parking lights were connected when you try to remote start the vhicle and it does not start they should flash X amount of times to tell you why it did not start. Just something to keep in mind. If theyw erent connected you can stick a test light on the parking light output and count the flashes.

Yes, the parking lights are connected, they blink when trying to remote start. I do not remember exactly .... 3 or 4 times. Today I will clarify.

Question. If I use version 70.18, connect the connection in accordance with Manual No. 23441?

Checked. When I try to start remotely, the ignition does not turn on. The parking lights flash 4 amount.

 

So. Remote start is working. Thank you for your advice. The device was in the valet mode, so remote startup was not performed.
But there was a problem when unlocking the doors using the remote control from the RF kit, disarming is not happening. When I open the door, the horn is triggered.
Problem! When the doors are unlocked using the remote control from the RF kit, disarming is not performed. When I open the door, a beep sounds.
In addition, when the remote startup is complete, the security system remains disarmed.
Thanks for any help.
...