Questions & Answers

Mitsubishi Pajero 2014, Petrol AT

0 votes
Well Ive tried to use Evo All for install a Pajero 2014 Petrol AT, the wire location is the same as  Eclispe, galant

http://fortin.ca/download/13931/evo-all_mitsubishi.rev-20140127.pdf

Ive used Avital 4113 D2D, Can High and Can Low 6 and 14 are different colours than the manual above, ive tried to remote start with the key inside and works, but when im going to program the Evo All, the blue light remain on and when I turn the engine to ON START, the blue light tunr off but not flashing as suppost to be. Can Low and Can High are connected well. what could be the issue? is it possible that CAN LOW and CAN High are different location or pin? Ive tried to invert them also but no success.

SN: 001A06514991

WITH EXTRA KEY will works , but I dont want to keep a key inside.

Ive tried to use hardwiring for the module, and same issue

Thanx
asked Aug 30, 2015 in Mitsubishi by Ara Her (770 points)

2 Answers

0 votes
If the light goes out when you turn ignition on, this means the module is not detecting Can-Bus. Reasons for this can vary, but revolve around either connections or firmware simply not being compatible.

 
From the listing on fortin.ca , we only cover transponder bypass on this car and nothing Can-Bus. I'm trying to get more info from Fortin Russia.
answered Aug 31, 2015 by Robert T (297,620 points)
0 votes
send me an email, i have a install guide for you but it's in Russian :D

robert.tamilio@ifar.ca
answered Aug 31, 2015 by Robert T (297,620 points)
Thanx Robert. Email sent
...